Skip to content

Tips and Best Practices ​

This page is for the tuning phase after your first working setup.

Start small ​

Do not hand the entire house to PELS on day one.

  • Start with a few flexible loads
  • Confirm that power reporting is stable
  • Watch the Overview tab during a real high-load hour

Once the behavior matches your expectations, expand the managed device set.

Priority advice ​

  • Water heaters are often good low-priority candidates because they store heat.
  • Living-room thermostats are usually high priority because comfort loss is obvious.
  • Bedroom heating is often higher priority at night than during the day.
  • Different modes should use different priority orders if comfort changes by time of day.

Capacity tuning advice ​

  • Set the limit slightly below the actual grid limit if you want extra safety.
  • A safety margin of 0.3 to 0.5 kW is a reasonable starting point.
    • On the hourly period, narrow it if PELS keeps limiting devices when the home is well below the hard cap. Widen toward 1.0 kW if PELS reacts later than you want — a larger margin pushes the safe pace further below the hard cap, so PELS starts limiting sooner.
    • On the 15-minute period, the margin is the whole buffer: PELS never paces above the hard cap minus the margin, so limiting while you are below the cap is the design rather than a sign the margin is too wide. Size it for your slowest device. Narrowing it because PELS limits below the cap removes the only room the quarter has to absorb a device that reacts late.
  • Use Simulation mode first if you want to see what PELS would do without touching real devices.

Price optimization advice ​

  • Thermal loads are usually the best targets.
  • Start with modest temperature adjustments, such as a 3 °C cheap-hour boost and a 3 °C expensive-hour reduction.
  • Set a minimum price difference so comfort is not traded away for tiny savings.

Daily budget advice ​

  • Treat daily budget as pacing, not as an emergency brake.
  • Leave the advanced tuning values at their defaults unless you have observed a real problem you are trying to solve.
  • Change one value at a time and observe a full day before making another adjustment.

Troubleshooting ​

ProblemWhat to check
No power samples receivedCheck Power source and Whole-home meter under Settings > Limits & safety. On the Flow card source, make sure a Flow calls Report power usage whenever your meter updates.
Devices do not appearOpen Devices > Missing a device? > Request support. Select the device to open its settings if it is already supported or send a support request.
PELS is not controlling devicesCheck Managed by PELS and that the device’s home is actively managing. For power limiting, also check Power-limit control and the device’s power reading. For temperature or price control, check the device’s target and Price-based control if applicable.
Expected power looks wrongCheck the device Energy settings in Homey or set a more accurate load in the device settings.
No price dataConfirm the configured source is correct and external Flow payloads contain full-day JSON.
EV charger current does not changeCheck the control model. For a supported charger, check that built-in control is on and not paused by a Flow. For other chargers, check the EV charger current (A) Flow tag and charger-app action.

For a symptom-by-symptom guide across all of PELS, see the full Troubleshooting guide.

When to dive deeper ​

Built for Homey Pro users who need tighter control over large loads.